Service and Facilities

Cold Rolling Mill

  • Fully flat shape of CRCA sheets through shift able Intermediate Roll (IMR)
  • Reduced edge drop through shift able IMR and bending force
  • Better grain structure due to higher reduction
  • Thickness close to nominal through Auto Gauge Control (AGC)
  • Uniform properties of the total coil length through elongation control during skin pass

TUBE DIVISION

  • We have 6 number of high speed tube mills with advance solid state welder.
  • We have one of the largest tube size range and we have large variety of ERW Precison Grade including micro alloy.
  • We also manufacture square, rectangle, oval tubes.
  • Low Carbon, High Carbon, Micro ALoy & Customers Specifiaction.
  • The use of the sophisticated equipment has given Hansa an edge over competition and has resulted in wide OD range 12.70mm to 95.5mm and thickness from 0.5mm-5.0mm, Hansa manufacture FIN CUT Tubes of OD as small as uptom 95.5mm.

CUTTING SECTION

  • We have 25 number of soco Cutting and Chamfering machiness.
  • We also have taper cutting soco machiness.
  • Our Cutting Section is one of the biggest under one roof.
  • Our cutting section enables us for the faster processing and shorter lead time.

LOGISTICS

  • 30 company owned transport vehicles for timely delivery.
  • All inward and outward material is transported by companies own vehicles.
  • All vehicles are GPS enabled.

WAREHOUSES

  • Ludhiana
  • Faridabad
  • Haridwar
  • Hosur
  • And shortly opening in Pune and Ahemdabad